Toyota 4Runner: Speed Sensor Circuit Malfunction (C1883/83)

Toyota 4Runner Service Manual / Suspension / Suspension Control / Kinetic Dynamic Suspension System / Speed Sensor Circuit Malfunction (C1883/83)

DESCRIPTION

The stabilizer control ECU receives the speed signal from the skid control ECU via CAN communication.

DTC Code	DTC Detection Condition	Trouble Area
C1883/83	The stabilizer control ECU continuously receives a speed sensor malfunction signal from the skid control ECU for 1 second.	Brake control system CAN communication system Stabilizer control ECU

CAUTION / NOTICE / HINT

HINT:

If DTC U0122/71 and C1883/83 are output at the same time, perform the inspection necessary for the CAN communication system first (See page ).

PROCEDURE

1.	CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

(a) Check for speed sensor malfunction DTCs (See page ).

Result

Result	Proceed to
DTC is not output	A
DTC is output	B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

2.	RECONFIRM DTC

(a) Clear the DTCs (See page ).

(b) Perform a road test.

Result

Result	Proceed to
DTC is not output	A
DTC is output	B

USE SIMULATION METHOD TO CHECK

REPLACE STABILIZER CONTROL ECU

Power Supply Voltage Malfunction (C1882/82)

DESCRIPTION The stabilizer control ECU recognizes the ignition switch ON signal based on the voltage input to the IG terminal. DTC Code DTC Detection Condition Tro ...

KDSS ECU Malfunction (C1881/81)

DESCRIPTION The stabilizer control ECU stores DTC C1881/81 when internal ECU malfunctions occur. DTC Code DTC Detection Condition Trouble Area C18 ...

Other materials about Toyota 4Runner:

Off-road vehicle feature
• Specific design characteristics give it a higher center of gravity than ordinary passenger cars. This vehicle design feature causes this type of vehicle to be more likely to rollover. And, utility vehicles have a significantly higher rollover rate th ...

Front Differential Side Gear Shaft Oil Seal(for 4wd)
Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT DRIVE SHAFT ASSEM ...