DESCRIPTION
Refer to "SRS Warning Light Remains ON" (See page ).
WIRING DIAGRAM
Refer to "SRS Warning Light Remains ON" (See page ).
CAUTION / NOTICE / HINT
NOTICE:
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (See page ).
PROCEDURE
1. |
CHECK BATTERY |
(a) Measure the voltage of the battery.
Standard voltage:
11 to 14 V
NG |
REPLACE OR RECHARGE BATTERY |
|
2. |
CHECK CONNECTORS |
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Check that the connectors are properly connected to the combination meter.
OK:
The connectors are properly connected.
NG |
CONNECT CONNECTORS PROPERLY |
|
3. |
CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER) |
(a) Turn the ignition switch off. |
|
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Disconnect the F14 connector from the combination meter.
(d) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
F14-17 (IG+) - F14-20 (E1) |
Ignition switch ON |
11 to 14 V |
F14-15 (B) - F14-20 (E1) |
Always |
11 to 14 V |
*a |
Front view of wire harness connector (to Combination Meter) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
4. |
CHECK SRS WARNING LIGHT (SHORT TO GROUND) |
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Connect the connector to the combination meter.
(d) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
(e) Turn the ignition switch to ON.
(f) Check the SRS warning light condition.
NOTICE:
Make sure that nobody is in the vehicle.
OK:
After the primary check period, the SRS warning light goes off for approximately 10 seconds and then remains on.
HINT:
The primary check period is approximately 6 seconds after the ignition switch is turned to ON.
OK |
REPLACE CENTER AIRBAG SENSOR ASSEMBLY |
NG |
GO TO METER / GAUGE SYSTEM |
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE BLOWER ASSEMBLY
(a) Remove the screw.
(b) Detach the 2 claws and remove the blower unit assembly.
2. REMOVE DEFROSTER NOZZLE ASSEMBLY
(a) Detach the 6 cl ...
The indicator and buzzer
When a sensor detects an obstacle, the direction of the obstacle is indicated
and the buzzer sounds.
Sensor operation and distance to an obstacle
The system operates when the vehicle approaches an obstacle, as shown by the
following table.
1. Rear cor ...