DESCRIPTION
The stabilizer control ECU receives steering angle information from the steering angle sensor via CAN communication.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1884/84 |
Either condition is met:
|
|
CAUTION / NOTICE / HINT
HINT:
If DTC U0126/71 and C1884/84 are output at the same time, perform the inspection necessary for the CAN communication system first (See page ).
PROCEDURE
1. |
CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Check for steering angle sensor malfunction DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) |
|
2. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Perform a road test.
(c) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
A |
USE SIMULATION METHOD TO CHECK |
B |
REPLACE STABILIZER CONTROL ECU |
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY
CAUTION:
Do not disassemble the retractor.
(a) Before installing the seat belt, check the ELR.
(1) When the inclination of the retractor is 15° or less, check that the belt
can be pulled ...
Short to GND in CAN Bus Line
DESCRIPTION
There may be a short circuit between the CAN bus lines and GND when the resistance
between terminals 6 (CANH) and 4 (CG) or terminals 14 (CANL) and 4 (CG) of the DLC3
is below 200 Ω.
Symptom
Trouble Area
...