Toyota 4Runner manuals

Toyota 4Runner: Steering Angle Sensor Internal Circuit (C1433)

DESCRIPTION

Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering angle sensor zero point malfunction diagnostic function.

DTC Code

DTC Detection Condition

Trouble Area

C1433

Either condition is met:

  1. With the IG1 terminal voltage at 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor for 0.012 seconds.
  2. An open in the sensor power supply circuit for 1 second or more.

Steering angle sensor (Spiral cable sub-assembly)

WIRING DIAGRAM

Refer to DTC C1432 (See page ).


CAUTION / NOTICE / HINT

HINT:

  • When any of the speed sensors or the yaw rate and acceleration sensor has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and acceleration sensor first, and then inspect and repair the steering angle sensor.

PROCEDURE

1.

CHECK DTC

(a) Check for DTCs (See page ).


Result

Result

Proceed to

CAN DTC is not output

A

CAN DTC is output

B


B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

A

2.

REPLACE SPIRAL CABLE SUB-ASSEMBLY

(a) Replace the spiral cable sub-assembly (See page ).


NOTICE:

  • Do not remove the steering angle sensor from the spiral cable.
  • When replacing the spiral cable, confirm that the replacement part is of the correct specification.

NEXT

END

Steering Angle Sensor Power Source Voltage Malfunction (C1432)
DESCRIPTION Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the ste ...

Steering Angle Sensor Output Malfunction (C1434)
DESCRIPTION Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the ste ...

Other materials about Toyota 4Runner:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very usefu ...

Installation
INSTALLATION PROCEDURE 1. INSTALL TURN SIGNAL FLASHER ASSEMBLY (a) Install the turn signal flasher assembly with the nut. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} (b) Connect the connector. 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY ...

© 2016-2024 | www.to4runner.net

0.0109