DESCRIPTION
If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
HINT:
DTC C1440 and the yaw rate and acceleration sensor DTC are stored when the skid control ECU determines that the vehicle is being driven at a steep bank angle and either of the following conditions is met:
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1440 |
Driving at a steep bank angle. |
Yaw rate and acceleration sensor |
PROCEDURE
1. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Perform a road test.
(c) Check if the same DTC is output (See page
).
Result |
Proceed to |
---|---|
DTC C1440 is output |
A |
DTC C1440 is not output |
B |
Yaw rate and acceleration sensor DTC is output |
C |
B |
END |
C |
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS |
|
2. |
CLEAR DTC |
(a) Clear the DTCs (See page ).
HINT:
NEXT |
END |
Slide Sensor Malfunction (B2650)
DESCRIPTION
When the front power seat switch LH does not receive a sensor signal despite
forward or backward movement of the seat by power seat motor operation, this DTC
is stored.
DTC Code
DTC Detection Condition
Trouble ...
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
Do not allow foreign matter, etc. to contact the rear axle hub and bearing assembly.
PROCEDURE
1. INSTALL BRAKE DRUM OIL DEFLECTOR LH
(a) Install a new deflector gasket and deflector to the rear axle shaft.
H ...