Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE ROOF HEADLINING ASSEMBLY
(a) Remove the roof headlining assembly (See page ).
3. REMOVE TELEPHONE ANTENNA ASSEMBLY
(a) Remove the antenna nut. |
|
(b) Disconnect the connector. |
|
(c) Detach the 2 claws and remove the telephone antenna.
Installation
INSTALLATION
PROCEDURE
1. INSTALL TELEPHONE ANTENNA ASSEMBLY
(a) Align the positioning pin of the telephone antenna with the hole and set the antenna on the vehicle. |
|
(b) Attach the 2 claws to install the telephone antenna.
(c) Connect the connector.
(d) Install the antenna nut.
Torque:
4.5 N·m {46 kgf·cm, 40 in·lbf}
2. INSTALL ROOF HEADLINING ASSEMBLY
(a) Install the roof headlining assembly (See page ).
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
4. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
Torque Converter Clutch And Drive Plate
Inspection
INSPECTION
PROCEDURE
1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY
(a) Inspect the 1-way clutch.
(1) Install SST to the inner race of the 1-way clutch.
SST: 09350-32014
09351-32020
(2) Press on the serrations of the starter with a finger a ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK
BODY ECU)
(a) Remove the main body ECU (multiplex network body ECU) (See page
).
(b) Measure the voltage and resistance according to the value(s) in the ...