Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE DRIVE MONITOR SWITCH
2. REMOVE MAP LIGHT ASSEMBLY
3. REMOVE TELEPHONE MICROPHONE ASSEMBLY
(a) Disconnect the 6 connectors. |
|
(b) Remove the screw. |
|
(c) Detach the 8 claws and remove the inner bezel. |
|
(d) Disconnect the connector. |
|
(e) Detach the 2 claws and remove the telephone microphone.
4. REMOVE AMPLIFIER MICROPHONE ASSEMBLY
(a) Disconnect the connector and remove the amplifier microphone. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL AMPLIFIER MICROPHONE ASSEMBLY
(a) Connect the connector and install the amplifier microphone.
2. INSTALL TELEPHONE MICROPHONE ASSEMBLY
(a) Attach the 2 claws to install the telephone microphone.
(b) Connect the connector.
(c) Attach the 8 claws to install the inner bezel.
(d) Install the screw.
(e) Connect the 6 connectors.
3. INSTALL MAP LIGHT ASSEMBLY
4. INSTALL DRIVE MONITOR SWITCH
Ignition Hold Monitor Malfunction (B2271)
DESCRIPTION
This DTC is stored when a problem, such as an open in the AM2 fuse, an open or
short in the wire harness between the fuse and power management control ECU, a short
in the IG output circuit inside the power management control ECU, a short betwe ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL PROPELLER SHAFT ASSEMBLY
(a) Remove SST from the extension housing.
SST: 09325-40010
(b) Install the propeller shaft assembly to the extension housing.
(c) Align the matchmarks on the propeller shaft flange and different ...