PROCEDURE
1. |
CHECK MULTI-DISPLAY |
(a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the multi-display.
HINT:
If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.
NG |
REMOVE ANY FOREIGN MATTER FOUND |
|
2. |
CHECK TOUCH PANEL |
(a) Check for foreign matter on the display.
OK:
The display is clean.
NG |
CLEAN DISPLAY AND RECHECK TOUCH PANEL |
|
3. |
CHECK TOUCH SWITCH (OPERATION CHECK) |
(a) Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check (See page ).
(b) Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
OK |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
NG |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Operating a USB memory
Connecting a USB memory enables you to enjoy music from the vehicle
speakers.
Connecting a USB memory
Pull up the lid.
Open the cover and connect a USB memory.
Turn on the power of the USB memory if it is not turned on.
Press
.
Control panel
S ...
Calibration
CALIBRATION
Initial Calibration of Compass:
The compass indicates the direction that the vehicle is heading by detecting
the direction and strength of the earth's magnetic field and processing this data
using the compass sensor and microcomputer. Det ...