DESCRIPTION
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1268 |
The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via CAN. |
|
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
PROCEDURE
1. |
INSPECT TRANSFER L4 SHIFT |
(a) Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.
Result
Result |
Proceed to |
---|---|
OK |
A |
NG (for Part-time 4WD) |
B |
NG (for Full-time 4WD) |
C |
B |
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) |
C |
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) |
|
2. |
RECONFIRM DTC |
(a) Clear the DTCs (See page ).
(b) Shift the transfer to L4, drive the vehicle, and then check for DTCs.
Result
Result |
Proceed to |
---|---|
DTC is output |
A |
DTC is not output |
B |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
USE SIMULATION METHOD TO CHECK |
Short to GND in Hall Effect Sensor Power Circuit (31)
DESCRIPTION
When there is a short to GND in the side auto step motor hall sensor power circuit,
the side auto step controller ECU assembly does not operate the automatic running
board.
DTC No.
Detection Condition
Trouble ...
Transponder Key Amplifier
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT TRANSPONDER KEY AMPLIFIER
(a) Apply battery voltage to the connector and check the LED illumination
condition.
OK:
Measurement Con ...