On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK TRANSFER OIL
(a) Remove the filler plug and gasket. |
|
(b) Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole. Text in Illustration
If the result is not as specified, add transfer oil. NOTICE: Too much or too little oil will lead to transfer problems. |
|
(c) When the oil level is too low, check for oil leaks.
(d) Install a new gasket to the filler plug and then tighten the plug.
Torque:
37 N·m {377 kgf·cm, 27 ft·lbf}
2. ADD TRANSFER OIL
(a) Remove the filler plug and gasket. |
|
(b) Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
NOTICE:
HINT:
Viscosity:
SAE 75W
Capacity:
1.0 liters (1.1 US qts, 0.9 lmp.qts)
(c) Wait approximately 5 minutes and check that the oil level has not changed.
(d) Install a new gasket to the filler plug and then tighten the plug.
Torque:
37 N·m {377 kgf·cm, 27 ft·lbf}
Replacement
REPLACEMENT
PROCEDURE
1. DRAIN TRANSFER OIL
(a) Remove the filler plug and gasket.
(b) Remove the drain plug and gasket, and drain the transfer oil.
2. ADD TRANSFER OIL
Downhill Assist Control Indicator Light Remains ON
DESCRIPTION
When the downhill assist control switch is turned on, the downhill assist control
function is available and the downhill assist control indicator light illuminates.
WIRING DIAGRAM
Refer to Downhill Assist Control Indicator Light does not Come ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the rear view monitor system.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...