Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT TRANSPONDER KEY AMPLIFIER
(a) Apply battery voltage to the connector and check the LED illumination condition. OK:
If the result is not as specified, replace the transponder key amplifier. Text in Illustration
|
|
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 2 SWITCH HOLE BASE
2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
4. REMOVE LOWER STEERING COLUMN COVER
5. REMOVE UPPER STEERING COLUMN COVER
6. REMOVE TRANSPONDER KEY AMPLIFIER
(a) Remove the screw and cover. |
|
(b) Turn the key amplifier as shown in the illustration to detach the 2 claws and remove the key amplifier. |
|
(c) Disconnect the connector.
Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSPONDER KEY AMPLIFIER
(a) Connect the connector. |
|
(b) Turn the key amplifier as shown in the illustration to attach the 2 claws and install the key amplifier.
(c) Install the cover with the screw.
2. INSTALL UPPER STEERING COLUMN COVER
3. INSTALL LOWER STEERING COLUMN COVER
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
6. INSTALL NO. 2 SWITCH HOLE BASE
Initialization
INITIALIZATION
1. PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL
Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
Necessary Procedure
Effect or Inoperative Function when N ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL KEY INTERLOCK SOLENOID WIRE (w/o Smart Key System)
(a) Install the key interlock solenoid wire on to the install the ignition switch.
2. INSTALL IGNITION SWITCH ASSEMBLY (w/o Smart Key System)
(a) Install the ign ...