DESCRIPTION
The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check.
Connecting terminals TS and CG of the DLC3 starts the check.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) |
(a) Turn the ignition switch off.
(b) Disconnect the A6 skid control ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
A6-24 (TS) - F13-12 (TS) |
Always |
Below 1 Ω |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
2. |
CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
F13-4 (CG) - Body ground |
Always |
Below 1 Ω |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
3. |
CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
F13-12 (TS) - Body ground |
Always |
10 kΩ or higher |
OK |
REPLACE MASTER CYLINDER SOLENOID |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Abbreviations Used In Manual
ABBREVIATIONS USED IN MANUAL
Abbreviation
Meaning
ABS
Anti-Lock Brake System
A/C
Air Conditioner
AC
Alternating Current
ACC
A ...
Engine (ignition) switch (vehicles without a smart key system)
Starting the engine
Check that the parking brake is
set.
Check that the shift lever is
set in P.
Firmly depress the brake pedal.
Turn the engine switch to the
“START” position to start the engine.
Changing the engine switch positions
1. ...