Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE LOWER STEERING COLUMN COVER
2. REMOVE UPPER STEERING COLUMN COVER
3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
4. REMOVE UNLOCK WARNING SWITCH ASSEMBLY
(a) Disconnect the unlock warning switch connector. |
|
(b) Detach the 3 claws and remove the cover.
(c) Remove the pin cap.
Text in Illustration
*1 |
Pin Cap |
Slide |
(d) Remove the unlock warning switch.
Inspection
INSPECTION
PROCEDURE
1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
1 (UN+) - 2 (UN-) |
Not pushed |
10 kΩ or higher |
Pushed |
Below 1 Ω |
If the result is not as specified, replace the unlock warning switch assembly.
Text in Illustration
*a |
Not pushed |
*b |
Pushed |
*c |
Component without harness connected (Unlock Warning Switch Assembly) |
Installation
INSTALLATION
PROCEDURE
1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY
(a) If reusing the unlock warning switch assembly:
(1) Install the unlock warning switch.
Text in Illustration
*1 |
Pin Cap |
Slide |
(2) Install the pin cap.
(3) Connect the unlock warning switch connector. |
|
(4) Attach the 3 claws to install the cover.
(b) If replacing the unlock warning switch assembly:
(1) While pushing the pin, slide the unlock warning switch to install it.
Text in Illustration
*1 |
Pin |
Slide |
(2) Connect the unlock warning switch connector. |
|
2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
3. INSTALL UPPER STEERING COLUMN COVER
4. INSTALL LOWER STEERING COLUMN COVER
Hitch
Trailer hitch assemblies have different weight capacities. Toyota recommends
the use of Toyota hitch/bracket for your vehicle. For details, contact your
Toyota dealer.
• If you wish to install a trailer hitch, contact your Toyota dealer.
• Use only a ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 COOLER THERMISTOR
NOTICE:
If reusing the evaporator, do not insert the thermistor into a location where
the thermistor was previously inserted.
(a) Insert the thermistor to a location that is 1 fin to the right or ...