Toyota 4Runner: Voice is not Recognized

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / Voice is not Recognized

CAUTION / NOTICE / HINT

NOTICE:

After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

PROCEDURE

1.	CHECK CONDITION

(a) Check if the system voice recognition level is low when recognizing a particular voice.

Result	Proceed to
System voice recognition level is low with any voice.	A
System voice recognition level is low only for a particular voice.	B

HINT:

System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.

END

2.	CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)

(a) Enter the "Microphone Check" screen. Refer to Check Microphone in Operation Check (See page ).

(b) When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

OK:

Check result are normal.

REPLACE NAVIGATION RECEIVER ASSEMBLY

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Route cannot be Calculated

PROCEDURE 1. SET DESTINATION (a) Set another destination and check if the system can calculate the route correctly. OK: Route can be correctly calculated. ...

Cellular Phone Registration Failure

CAUTION / NOTICE / HINT NOTICE: After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary. HINT: If th ...

Other materials about Toyota 4Runner:

Road Test
ROAD TEST 1. PROBLEM SYMPTOM CONFIRMATION (a) Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transmission does not shift up or shift down, or that the shift point is too high or too low, co ...

Back Door Support
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE BACK DOOR DAMPER STAY SUB-ASSEMBLY LH NOTICE: Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the ...