Toyota 4Runner manuals

Toyota 4Runner: Washer Motor(for Rear Side)

Components

COMPONENTS

ILLUSTRATION


Removal

REMOVAL

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


2. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)

(See page )


3. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)

(See page )


4. REMOVE FRONT FENDER LINER RH

(See page )


5. DRAIN WINDSHIELD WASHER FLUID


6. REMOVE WASHER INLET SUB-ASSEMBLY


7. REMOVE WASHER JAR


8. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY

(a) Remove the rear washer motor and pump assembly from the packing of the washer jar.

Text in Illustration

*1

Packing


Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR WASHER MOTOR AND PUMP ASSEMBLY

(a) Remove the washer jar.

(b) Disconnect the rear washer motor and pump connector.

HINT:

Make sure that the rear washer motor and pump is installed to the washer jar.

(c) Fill the washer jar with washer fluid.

(d) Connect the positive (+) lead of the battery to terminal 1 of the rear washer motor and pump and the negative (-) lead to terminal 2.


(e) Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.

If the result is not as specified, replace the rear washer motor and pump assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR WASHER MOTOR AND PUMP ASSEMBLY

(a) Install the rear washer motor and pump assembly to the packing of the washer jar.

2. INSTALL WASHER JAR


3. INSTALL WASHER INLET SUB-ASSEMBLY


4. FILL WINDSHIELD WASHER FLUID


5. INSTALL FRONT FENDER LINER RH

(See page )


6. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)

(See page )


7. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)

(See page )


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


9. ADJUST FOG LIGHT AIMING

(See page )


Installation
INSTALLATION PROCEDURE 1. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (a) Install the windshield washer motor and pump assembly to the packing of the washer jar. 2. INSTALL WASHER JAR ...

Washer Nozzle(for Front Side)
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WASHER NOZZLE SUB-ASSEMBLY (a) With the engine running, check the position that the was ...

Other materials about Toyota 4Runner:

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSION HINT: The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ign ...

Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH 2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH 3. REMOVE HEATER CONTROL ASSEMBLY 4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBL ...

© 2016-2024 | www.to4runner.net

0.0246