Toyota 4Runner: Washer Nozzle(for Front Side)

Toyota 4Runner Service Manual / Vehicle Exterior / Wiper / Washer / Washer Nozzle(for Front Side)

Components

COMPONENTS

ILLUSTRATION

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT WASHER NOZZLE SUB-ASSEMBLY

(a) With the engine running, check the position that the washer fluid hits the windshield.

Standard:

Washer fluid hits the windshield in the areas shown in the illustration.

Text in Illustration

*1	Ceramic Line	-	-
*a	Upper Limit	*b	Standard
*c	Lower Limit	-	-
	Washer Fluid Spray Area	-	-

Standard:

Area	Measurement	Area	Measurement
A	254.5 mm (10.0 in.)	B	150 mm (5.91 in.)
C	127.6 mm (5.02 in.)	-	-

If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.

Removal

REMOVAL

PROCEDURE

1. REMOVE WASHER NOZZLE SUB-ASSEMBLY

(a) Using a screwdriver, detach the 2 claws and disconnect the washer nozzle sub-assembly as shown in the illustration.

HINT:

Tape the screwdriver tip before use.

Text in Illustration

*1	Protective Tape

NOTICE:

Be careful not to damage the windshield.

(b) Remove the washer nozzle sub-assembly from the washer hose.

NOTICE:

Washer nozzles cannot be reused.

Adjustment

ADJUSTMENT

PROCEDURE

1. REMOVE WASHER NOZZLE SUB-ASSEMBLY

2. ADJUST WASHER NOZZLE SUB-ASSEMBLY

(a) Select a washer nozzle so that the washer fluid spray area is as specified in On-vehicle Inspection. Replace the washer nozzle with the selected one.

Text in Illustration

*1	Available Washer Nozzles	*2	Washer Fluid Spray Angle
*3	Part Number	-	-

3. INSTALL WASHER NOZZLE SUB-ASSEMBLY

Installation

INSTALLATION

PROCEDURE

1. INSTALL WASHER NOZZLE SUB-ASSEMBLY

(a) Connect a new washer nozzle sub-assembly to the washer hose.

(b) Attach the 2 claws to install the washer nozzle sub-assembly.

2. INSPECT WASHER NOZZLE SUB-ASSEMBLY

3. ADJUST WASHER NOZZLE SUB-ASSEMBLY

Washer Motor(for Rear Side)

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized ...

Washer Nozzle(for Rear Side)

Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: The washer fluid does not spray if the back door and back door glass are not ...

Other materials about Toyota 4Runner:

Registration
REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION The key has 2 codes: the key code (immobiliser code) and the wireless code (recognition code). Both of these codes need to be registered. For wireless code registration procedures, refer to the ...

CD cannot be Ejected
PROCEDURE 1. CHECK OPERATION (a) Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the CD is ejected. OK: CD is ejected. NG REPLACE RADIO AND D ...