Toyota 4Runner: Zero Point Calibration of Acceleration Sensor Undone (C1879/79)

Toyota 4Runner Service Manual / Suspension / Suspension Control / Kinetic Dynamic Suspension System / Zero Point Calibration of Acceleration Sensor Undone (C1879/79)

DESCRIPTION

The stabilizer control ECU receives the yaw rate and acceleration sensor zero point information from the skid control ECU via CAN communication.

DTC Code	DTC Detection Condition	Trouble Area
C1879/79	A signal indicating that the yaw rate and acceleration sensor zero point calibration has not been performed is continuously received from the skid control ECU for 5 seconds.	Brake control system (Yaw rate and acceleration sensor zero point calibration) Stabilizer control ECU

CAUTION / NOTICE / HINT

HINT:

When this DTC is output, obtain the calibration value of the yaw rate and acceleration sensor zero point first.

PROCEDURE

1.	PERFORM ZERO POINT CALIBRATION

(a) Perform brake control system calibration (See page ).

2.	RECONFIRM DTC

(a) Clear the DTCs (See page ).

(b) Check for DTCs (See page ).

Result

Result	Proceed to
DTC is output	A
DTC is not output	B

REPLACE STABILIZER CONTROL ECU

END

Acceleration Sensor Circuit Malfunction (C1887/87)

DESCRIPTION The stabilizer control ECU receives forward, backward and lateral acceleration information from the yaw rate and acceleration sensor via CAN communication. DTC Code ...

Stabilizer Control Ecu

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the n ...

Other materials about Toyota 4Runner:

Initialization
INITIALIZATION 1. PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL NOTICE: After the battery is reconnected, be sure to wait 10 seconds or more before attempting to start the engine. The engine may not start immedi ...

Open or Short in Rear Speed Sensor RH Circuit (C1407,C1408)
DESCRIPTION Refer to DTCs C1401 and C1402 (See page ). DTC Code DTC Detection Condition Trouble Area C1407 C1408 Either condition is met: An open in the speed sensor signal circui ...