Toyota 4Runner manuals

Toyota 4Runner: Locking the doors from the outside without a key

Toyota 4Runner Owners Manual / Before driving / Opening, closing and locking the doors / Side doors / Locking the doors from the outside without a key

Move the inside lock button to
the lock position.

Close the door.


Vehicles without a smart key system

The door cannot be locked if either of the front doors is open and the key is in the engine switch.

Vehicles with a smart key system

The door cannot be locked if the “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode, or the electronic key is left inside the vehicle.

The key may not be detected correctly and the door may be locked.

Side doors
The vehicle can be locked and unlocked using the entry function, wireless remote control, key or door lock switch. Entry function (vehicles with a smart key system) Wireless remote control Key ...

Rear door child-protector lock
The door cannot be opened from inside the vehicle when the lock is set. 1. Unlock 2. Lock These locks can be set to prevent children from opening the rear doors. Push down on each rear door sw ...

Other materials about Toyota 4Runner:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER SIDE BRACKET LH (a) Attach the guide. (b) Install the rear bumper side bracket LH with the 2 screws and clip. 2. INSTALL REAR BUMPER SIDE BRACKET RH HINT: Use the same procedure as for the LH side. 3. INSTALL ...

Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
DESCRIPTION The driver side squib 2nd step circuit consists of the center airbag sensor, spiral cable and steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the ...

© 2016-2020 | www.to4runner.net

0.006