Toyota 4Runner manuals

Toyota 4Runner: Operating the system using a voice command

By following voice guidance instructions output from the speaker, voice commands enable the operation of the hands-free phone system without the need to check the display or operate .


Operation procedure when using a voice command

Press the talk switch and follow voice guidance instructions.

Auxiliary commands when using a voice command

The following auxiliary commands can be used when operating the system using a voice command:

“Cancel”: Exits the hands-free phone system

“Repeat”: Repeats the previous voice guidance instruction

“Go back”: Returns to the previous procedure

“Help”: Reads aloud the function summary if a help comment is registered for the selected function

Using the hands-free phone system (for cellular phone)
Audio unit 1. Display A message, name, phone number, etc. is displayed. Lower-case characters and special characters, such as an umlaut, cannot be displayed. 2. Selects speed dials 3. Selects i ...

Using the hands-free phone system for the first time
Before using the hands-free phone system, it is necessary to register a cellular phone in the system. The phone registration mode will be entered automatically when starting the system with no cel ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR AXLE SHAFT RH (a) Remove the rear axle shaft RH (See page ). 2. REMOVE REAR AXLE SHAFT LH HINT: Use the same procedure described for the RH side. 3. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft asse ...

Short in GPS Antenna (B15C0,B15C1)
DESCRIPTION This DTC is stored when the DCM (Telematics Transceiver) detects an open or a short in the telephone and GPS antenna circuit. The DCM (Telematics Transceiver) receives signals at a radio frequency of between 1574.42 and 1576.42 MHz through t ...

© 2016-2021 | www.to4runner.net

0.0055