REASSEMBLY
PROCEDURE
1. INSTALL TRANSFER POSITION SWITCH (for VF2BM)
2. INSTALL TRANSFER POSITION SWITCH (for VF4BM)
3. INSTALL NO. 2 BOX BOTTOM MAT (for 2WD)
(a) Attach the 4 claws to install the No. 2 box bottom mat.
4. INSTALL FRONT UPPER CONSOLE PANEL GARNISH
(a) for VF2A:
(1) Attach the 6 claws to install the front upper console panel garnish.
(b) for 2WD, for VF2BM, VF4BM:
(1) Attach the 10 claws to install the front upper console panel garnish.
5. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for VF2A)
(a) Attach the 6 claws to install the shifting hole cover sub-assembly.
6. INSTALL SWITCH BASE
(a) Install the switch base with the 2 screws.
7. INSTALL SEAT HEATER SWITCH (w/ Seat Heater System)
8. INSTALL BACK DOOR POWER WINDOW REGULATOR SWITCH ASSEMBLY
9. INSTALL CONSOLE CUP HOLDER BOX
(a) Install the console cup holder box with the 6 screws.
10. INSTALL CONSOLE COMPARTMENT DOOR HINGE SUB-ASSEMBLY
(a) Install the console compartment door hinge sub-assembly with the 4 screws.
(b) Attach the 6 claws to install the console compartment inner door.
(c) Install the 4 screws.
11. INSTALL CONSOLE COMPARTMENT DOOR LOCK SUB-ASSEMBLY
(a) Install the console compartment door lock sub-assembly with the 2 screws.
12. INSTALL CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY
(a) Install the console compartment door sub-assembly with the 6 screws.
13. INSTALL CONSOLE BOX REGISTER ASSEMBLY
(a) Attach the 4 claws to install the console box register assembly.
14. INSTALL CENTER POWER OUTLET SOCKET COVER
15. INSTALL NO. 3 POWER OUTLET SOCKET ASSEMBLY
16. INSTALL REAR CONSOLE END PANEL
(a) Connect the 2 power outlet socket assembly connectors.
(b) Attach the 4 clips and 4 claws to install the rear console end panel.
17. INSTALL NO. 1 POWER OUTLET SOCKET COVER
18. INSTALL NO. 1 POWER OUTLET SOCKET ASSEMBLY
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 COOLER THERMISTOR
NOTICE:
If reusing the evaporator, do not insert the sensor into a location where the
sensor was previously inserted.
(a) Insert the sensor to a location that is 1 fin to the right or left of its ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY
(a) Using a center punch, mark the center of the tapered-head bolt.
(b) Using a 3 to 4 mm (0.118 to 0.157 in.) drill, drill a hole in the 2 bolts.
(c) Using a screw extractor, remo ...