Toyota 4Runner manuals

Toyota 4Runner: Seat heaters


1. On The indicator light comes on.

2. Adjusts the seat temperature The further you move the dial forward, the warmer the seat becomes.

The seat heaters can be used when

Vehicles without a smart key system

The engine switch is in the “ON” position.

Vehicles with a smart key system

The “ENGINE START STOP” switch is in IGNITION ON mode.

When not in use

Move the dial fully backward. The indicator light turns off.

CAUTION

Burns

• Use caution when seating the following persons in a seat with the seat heater on to avoid the possibility of burns:

• Babies, small children, the elderly, the sick and the physically challenged


• Persons with sensitive skin

• Persons who are fatigued

• Persons who have taken alcohol or drugs that induce sleep (sleeping drugs, cold remedies, etc.)

• Do not cover the seat with anything when using the seat heater.

Using the seat heater with a blanket or cushion increases the temperature of the seat and may lead to overheating.

• Do not use the seat heater more than necessary. Doing so may cause minor burns or overheating.

NOTICE

To prevent seat heater damage

Do not put heavy objects that have an uneven surface on the seat and do not stick sharp objects (needles, nails, etc.) into the seat.

To prevent battery discharge

Turn the seat heaters off when the engine is not running.

Power outlets (120 V AC)
The power outlet can be used for electrical appliances. Main switch To use the power outlet, turn on the main switch. The power supply starts a few seconds after the main switch is pressed. Powe ...

Armrest
Fold down the armrest for use. NOTICE To prevent damage to the armrest Do not apply too much load on the armrest. ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Temporarily install the set bolt. (b) Install the hydraulic brake booster (See page ). (c) tighten the brake pedal support sub-assembly with the 4 nuts. Torque: 14 N·m {145 kgf·cm, ...

Television Camera(for Rear)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE ASSIST STRAP HOLE COVER 2. REMOVE ASSIST STRAP ASSEMBLY 3. REMOVE BACK DOOR TRIM PANEL ASSEMBLY 4. REMOVE MULTIPLEX NETWORK DOOR ECU 5. REMOVE NO. 2 BACK DOOR SE ...

© 2016-2019 | www.to4runner.net

0.0028