Toyota 4Runner manuals

Toyota 4Runner: Selecting trailer ball

Use the correct trailer ball for your application.


1. Trailer ball load rating Matches or exceeds the gross trailer weight rating of the trailer.

2. Ball diameter Matches the size of the trailer coupler. Most couplers are stamped with the required trailer ball size.


3. Shank length Protrudes beyond the bottom of the lock washer and nut by at least 2 threads.

4. Shank diameter Matches the ball mount hole diameter size.

Positions for towing hitch receiver and hitch ball


1. Weight carrying ball position:

50.1 in. (1272 mm)

2. Hitch receiver pin hole position:

43.7 in. (1109 mm)

Hitch
Trailer hitch assemblies have different weight capacities. Toyota recommends the use of Toyota hitch/bracket for your vehicle. For details, contact your Toyota dealer. • If you wish to install ...

Connecting trailer lights
 Use the wire harness stored in the rear end under body. Service connector for towing brake controller Your vehicle is equipped with a service connector for the trailer brake controller a ...

Other materials about Toyota 4Runner:

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are output by the blinking of the tire pressure warning light. WIRING DIAGRAM HINT: When each warning light blinks continuously, a ground short in the w ...

Inspection
INSPECTION PROCEDURE 1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (a) Check the ELR. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor ...

© 2016-2020 | www.to4runner.net

0.0062