Toyota 4Runner: Cellular Phone Inspection

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / Cellular Phone Inspection

CAUTION / NOTICE / HINT

HINT:

If the operation of a cellular phone or the navigation receiver assembly is requested, make sure to follow the instructions closely and perform the operation.

PROCEDURE

1.	CHECK USAGE CONDITION

(a) Check that the vehicle and cellular phone meet the following conditions:

HINT:

If changing cellular phone settings, updating software, etc. is necessary, make sure to obtain the permission of the customer before performing it.

The cellular phone is "Bluetooth" compatible (Refer to http://www.toyota.com/entune/enside.html).
The cellular phone is registered as a hands-free device.
"Bluetooth" setting of the cellular phone is on.
Operating system and software of the cellular phone are the latest versions.
There are no other radio wave emitting devices ("Wi-Fi" communication device, etc.) in the cabin.

(b) Connect the cellular phone to the in-vehicle device and check that it is connected correctly.

OK:

The cellular phone is connected correctly.

END (USAGE CONDITIONS DEFECTIVE)

2.	RESTART CELLULAR PHONE

(a) Restart the cellular phone.

(b) Turn the ignition switch off.

(d) Connect the cellular phone to the in-vehicle device and check that it is connected correctly.

OK:

The cellular phone is connected correctly.

END (TEMPORARY MALFUNCTION WITH "Bluetooth" OF CELLULAR PHONE)

3.	REGISTRATION AGAIN

(a) Check if the in-vehicle device can be recognized by the cellular phone.

OK:

The cellular phone is connected correctly.

GO TO STEP 5

4.	REGISTRATION AGAIN

(a) Clear all "Bluetooth" devices registered to the cellular phone and navigation receiver assembly.

(b) Register the cellular phone again.

OK:

The cellular phone is connected correctly.

END (TEMPORARY MALFUNCTION WITH "Bluetooth")

GO TO STEP 6

5.	CHECK USING ANOTHER VEHICLE

(a) Check if the customer's cellular phone functions normally using another "Bluetooth" compatible vehicle.

HINT:

Make sure to obtain the customer's permission to perform this procedure.
After the inspection, clear the registered information and usage history acquired during the inspection.

OK:

The cellular phone is connected correctly.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

CHECK USING ANOTHER CELLULAR PHONE

6.	CHECK USING ANOTHER CELLULAR PHONE

(a) Check if the system functions normally using another "Bluetooth" compatible cellular phone.

HINT:

Make sure to obtain the customer's permission to perform this procedure.
After the inspection, clear the registered information and usage history acquired during the inspection.

OK:

The cellular phone is connected correctly.

END (ONLY A "Bluetooth" COMPATIBLE CELLULAR PHONE CAN BE USED)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Cellular Phone Registration Failure

CAUTION / NOTICE / HINT NOTICE: After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary. HINT: If th ...

Confirm Cellular Phone Functionality

PROCEDURE 1. CHECK THE CUSTOMER'S CELLULAR PHONE COMPATIBILITY (a) Go to TIS "Bluetooth" Compatibility Portal and check if the cellular phone is compa ...

Other materials about Toyota 4Runner:

XM Tuner Malfunction (B15BA)
DESCRIPTION These DTCs are stored when a malfunction occurs in the stereo component tuner assembly. DTC Code DTC Detection Condition Trouble Area B15BA When either of the conditions below is met: ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH (a) Disconnect the b2 seat heater control sub-assembly LH connector. (b) Measure the resistance according to the value( ...