Toyota 4Runner: Customize Parameters
CUSTOMIZE PARAMETERS
1. CUSTOMIZING FUNCTION WITH TECHSTREAM
HINT:
The following items can be customized.
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Record the current settings before customizing.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Customize.
(e) Select the setting by referring to the table below.
Door Lock|
Display |
Default |
Content |
Setting |
|---|---|---|---|
|
Auto Lock |
OFF |
Function that locks all doors when the vehicle speed reaches a certain level. |
ON or OFF |
|
Auto Lock/Shift |
ON |
Function that locks all doors when the shift lever is moved from P to any position other than P while the engine is running and all doors are closed. |
ON or OFF |
|
Auto Unlock/Shift |
ON |
Function that unlocks all doors when the shift lever is moved to P from any position other than P while the ignition switch is ON. |
ON or OFF |
|
All Unlock/Open-Close |
OFF |
Function that unlocks the other doors when the driver door is opened within 10 seconds after the ignition switch is turned off. |
ON or OFF |
System Description
SYSTEM DESCRIPTION
1. POWER DOOR LOCK CONTROL SYSTEM DESCRIPTION
(a) The power door lock system locks/unlocks all the doors.
The driver and front passenger side door control switches send lock/unlo ...
Operation Check
OPERATION CHECK
1. CHECK POWER DOOR LOCK OPERATION
NOTICE:
The operation check below is based on the non-customized initial condition of
the vehicle.
(a) Check basic functions.
(1) Check that a ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
(a) Align the matchmarks on the yoke and differential flange.
(b) Install the propeller shaft assembly with the 4 washers, 4 bolts and 4 nuts.
Torque:
88 N·m {899 kgf·cm, 65 ft·lbf}
(c ...
Inspection
INSPECTION
PROCEDURE
1. CHECK PAD LINING THICKNESS
(a) Using a ruler, measure the pad lining thickness.
Standard thickness:
10.0 mm (0.394 in.)
Minimum thickness:
1.0 mm (0.0394 in.)
If the pad lining thickness is less than the m ...
0.0128