Toyota 4Runner: Deactivating the curtain shield airbags in a vehicle rollover
On/off (hold for a few seconds)
Vehicles without a smart key system: The “RSCA OFF” indicator turns on. (only when the engine switch is in the “ON” position).
The roll sensing function for the curtain shield airbags and seat belt pretensioners will turn back on automatically each time the engine switch is turned to the “ON” position.
Vehicles with a smart key system: The “RSCA OFF” indicator comes on. (only when the “ENGINE START STOP” switch is in IGNITION ON mode).
The roll sensing function for the curtain shield airbags and seat belt pretensioners will turn back on automatically each time the “ENGINE START STOP” switch is turned to IGNITION ON mode.
This switch only should be used
In a situation where the inflation is not desired (such as during extreme offroad driving).
Operating conditions when the “RSCA OFF” indicator is illuminated
• The curtain shield airbags and seat belt pretensioner will not activate in a vehicle rollover.
• The curtain shield airbags will activate in a severe side impact.
• The seat belt pretensioner will activate in a severe frontal or side collision.
CAUTION
During normal driving
Make sure the “RSCA OFF” indicator light is not turned on. If it is left on, the curtain shield airbags will not activate in the event of an accident, which may cause death or serious injury.
SRS airbag system components
1. Side airbags
2. “AIR BAG ON” and “AIR BAG OFF” indicator lights
3. Curtain shield airbags
4. Front passenger airbag
5. Knee airbags
6. Side and curtain shield airbag sensors
7 ...
Front passenger occupant classification system
Your vehicle is equipped with a front passenger occupant classification
system. This system detects the conditions of the front passenger seat and
activates or deactivates the devices for the fron ...
Other materials about Toyota 4Runner:
Floor mat
Use only floor mats designed specifically for vehicles of the same model
and model year as your vehicle. Fix them securely in place onto the carpet.
Insert the retaining hooks (clips) into the floor mat eyelets.
Turn the upper knob of each retaining ho ...
Noise Occurs
PROCEDURE
1.
NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear
left or right).
OK:
The location of the noise source can be determined.
NG
GO TO STEP 3
...
0.0216