Toyota 4Runner: Disassembly

Toyota 4Runner Service Manual / Brake / Brake System (other) / Brake Pedal(for Vacuum Brake Booster) / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE BRAKE PEDAL PAD

(a) Remove the brake pedal pad from the brake pedal sub-assembly.

2. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

(a) Remove the stop light switch mounting adjuster from the brake pedal support assembly.

Removal

REMOVAL CAUTION / NOTICE / HINT PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery termin ...

Adjustment

ADJUSTMENT PROCEDURE 1. CHECK BRAKE PEDAL HEIGHT (a) Check the brake pedal height. Pedal height from Floor panel: 158.8 to 168.8 mm (6.25 to 6.46 in.) Text in Illustration ...

Other materials about Toyota 4Runner:

ACC Signal Circuit
DESCRIPTION This circuit detects the ignition switch ACC or off condition, and sends it to the main body ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspec ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE CYLINDER BOOT (a) Using a screwdriver, remove the cylinder boot from the rear disc brake cylinder. HINT: Tape the screwdriver tip before use. 2. REMOVE REAR DISC ...