Toyota 4Runner: Disc cannot be Ejected

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / Disc cannot be Ejected

CAUTION / NOTICE / HINT

NOTICE:

After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

PROCEDURE

1.	CHECK OPERATION

(a) Press the disc eject switch of the navigation receiver assembly for 2 seconds or more and check that the disc is ejected.

OK:

Disc is ejected.

REPLACE NAVIGATION RECEIVER ASSEMBLY

2.	REPLACE DISC AND RECHECK

(a) Replace the disc with a known good one and check that the malfunction disappears.

OK:

Disc is ejected.

END (DISC WAS FAULTY)

REPLACE NAVIGATION RECEIVER ASSEMBLY

Sound Quality is Bad Only when Disc is Played (Volume is Too Low)

CAUTION / NOTICE / HINT NOTICE: After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary. PROCEDURE ...

Disc cannot be Inserted or is Ejected Right After Insertion

CAUTION / NOTICE / HINT NOTICE: After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary. PROCEDURE ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR DISC (a) Align the matchmarks and install the rear disc. HINT: When re ...

High Power Supply Voltage Malfunction (C1417)
DESCRIPTION If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRAC operation. This DTC is stored when the IG1 terminal volt ...