Toyota 4Runner: Dtc Check / Clear

Toyota 4Runner Service Manual / Vehicle Exterior / Sliding Roof / Convertible / Sliding Roof System / Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.

(e) Check the DTCs.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.

(e) Clear the DTCs.

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (a) Disconnect the S10 sliding roof drive gear sub-assembly connector. (b) Measure the resistance and voltage acc ...

Data List / Active Test

DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH (a) Install the front bumper bracket sub-assembly LH with the 2 ...

Control Module Communication Bus OFF (U0073,U0100,U0114,U0123,U0124,U0126)
DESCRIPTION DTC Code DTC Detection Conditions Trouble Area U0073 One of the following conditions is met: When the IG1 terminal voltage is between 10 and 17.4 V, after the output ...