Toyota 4Runner: Dtc Check / Clear

Toyota 4Runner Service Manual / Vehicle Exterior / Window / Glass / Power Window Control System / Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

(e) Check the details of the DTC(s)

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

(e) Clear the DTCs.

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the h1 multiplex network master switch connector. (b) Measure the voltage and resistance according to the value(s ...

Data List / Active Test

DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) Hold the drive shaft lightly in a vise between aluminum plates. (b) Using pliers, remove the front No. 2 axle inboard joint boot clamp as shown in the illustration ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH (a) Attach the claw to install the ou ...