Toyota 4Runner: GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly.

DTC No.	DTC Detection Condition	Trouble Area
B15C0	Navigation antenna error	Navigation antenna cord Navigation antenna assembly Navigation receiver assembly
B15C1	Error of the power source to the navigation antenna

CAUTION / NOTICE / HINT

NOTICE:

After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs and check if the same DTC are output again.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

2.	CHECK CONNECTION OF NAVIGATION ANTENNA CORD

(a) Check if the navigation antenna cord is securely connected to the navigation receiver assembly.

OK:

Navigation antenna cord is securely connected.

SECURELY CONNECT NAVIGATION ANTENNA CORD

3.	INSPECT NAVIGATION ANTENNA ASSEMBLY

(a) Remove the navigation antenna assembly (See page ).

(b) Inspect the navigation antenna assembly (See page ).

REPLACE NAVIGATION RECEIVER ASSEMBLY

REPLACE NAVIGATION ANTENNA ASSEMBLY

XM Tuner Malfunction (B15BA)

DESCRIPTION These DTCs are stored when a malfunction occurs in the stereo component tuner assembly. DTC Code DTC Detection Condition Trouble Area ...

Speed Signal Malfunction (B15C2)

DESCRIPTION The navigation receiver assembly receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna assembly, and then adjusts the vehicle ...

Other materials about Toyota 4Runner:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very usefu ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER LINK ASSEMBLY (a) Install the rear stabilizer link assembly with the bolt and nut. Torque: 100 N·m {1020 kgf·cm, 74 ft·lbf} HINT: Turn the nut while holding the bolt. 2. INSTALL REAR STABILIZER CONT ...