Toyota 4Runner: How To Proceed With Troubleshooting

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Wireless Door Lock Control System(w/ Smart Key System) / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
Use these procedures to troubleshoot the wireless door lock control system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

3.	CHECK FOR DTC*

(a) Check for DTCs and note any codes that are output (See page ).

(b) Clear the DTCs (See page ).

(c) Recheck for DTCs (See page ). Based on the
DTCs output above, try to force output of the same CAN communication system DTC, LIN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.

Result	Proceed to
DTC is not output	A
CAN communication system DTC is output	B
LIN communication system DTC is output	C
Wireless door lock control system DTC is output	D

GO TO CAN COMMUNICATION SYSTEM

GO TO LIN COMMUNICATION SYSTEM

GO TO DIAGNOSTIC TROUBLE CODE CHART

4.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page
).

Result	Proceed to
Fault is not listed in problem symptoms table	A
Fault is listed in problem symptoms table	B

GO TO STEP 6

5.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check (See page ).

(b) Terminals of ECU (See page ).

6.	REPAIR OR REPLACE

7.	CONFIRMATION TEST

END

System Diagram

SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Certification ECU Main body ECU Door unl ...

Customize Parameters

CUSTOMIZE PARAMETERS 1. CUSTOMIZING FUNCTION WITH TECHSTREAM NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure ...

Other materials about Toyota 4Runner:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK TIRE PRESSURE WARNING ECU HINT: Inspect the connector from the back side. (a) Disconnect the F7 ECU connector. (b) Measure the voltage according to the value(s) in the table below. Terminal No. (Symbol) W ...

General Maintenance
GENERAL MAINTENANCE PROCEDURE 1. INSPECT STEERING LINKAGE AND GEAR HOUSING (a) Check the steering wheel free play. (b) Check the steering linkage for looseness or damage. (1) Check that the tie rod ends do not have excessive play. (2) Check that the dust ...