Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Suspension / Front Suspension / Front Shock Absorber / Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY LH

(a) Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual sound during operation.

If there is any abnormality, replace the front shock absorber assembly LH with a new one.

NOTICE:

When disposing of the front shock absorber assembly LH, refer to Disposal (See page ).

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT (a) Secure SST in a vise. SST: 09727-30021 09727-00010 09727-00031 SST: 09727-00060 ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL FRONT SHOCK ABSORBER BUSH (a) Using SST and a press, install a new absorber bush. SST: 09710-30012 09710-04071 09710-04081 ...

Other materials about Toyota 4Runner:

Power Source Mode does not Change to ON (ACC)
DESCRIPTION When the engine switch is pushed with the key in the cabin, the power management control ECU receives signals to switch the power source mode. HINT: To allow use of the Techstream to inspect the push-button start function when the engine swi ...

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 OIL COOLER TUBE SUB-ASSEMBLY (a) Temporarily install the oil cooler tube to the fan shroud with bolt A. Install bolt B and tighten it to the specified torque. Then tighten bolt A to the specified to ...