Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL LEVEL WARNING SWITCH ASSEMBLY
(a) Install the level warning switch assembly to the packing of the washer jar.
2. INSTALL WASHER JAR PROTECTOR
(a) Attach the 3 claws to install the washer jar protector.
3. INSTALL WASHER JAR
.gif)
4. INSTALL WASHER INLET SUB-ASSEMBLY
5. FILL WINDSHIELD WASHER FLUID
6. INSTALL FRONT FENDER LINER RH
(See page )
7. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(See page )
8. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(See page )
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
10. ADJUST FOG LIGHT AIMING
(See page )
Inspection
INSPECTION
PROCEDURE
1. INSPECT LEVEL WARNING SWITCH ASSEMBLY
HINT:
The following check should be performed with the windshield washer motor and
pump installed to the washer jar.
(a) Fill the w ...
Other materials about Toyota 4Runner:
All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless
Transmitter
DESCRIPTION
When a key switch is pushed: 1) the door control receiver receives the
key signal; 2) the door control receiver sends a signal to the certification
ECU; 3) the main body ECU (multiplex network body ECU) sends the operation
permi ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
(a) Apply MP grease to a new O-ring.
(b) Inst ...
0.027