Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Front Bumper(w/ Intuitive Parking Assist System) / Removal

REMOVAL

PROCEDURE

1. REMOVE UPPER RADIATOR SUPPORT SEAL

2. REMOVE FRONT BUMPER COVER

(a) Put protective tape around the front bumper cover.

(b) Remove the 3 bolts, 10 screws and 6 clips.

Text in Illustration

Protective Tape

(d) Disconnect 3 connectors.

3. REMOVE UPPER CENTER FRONT BUMPER RETAINER

4. REMOVE COOL AIR INTAKE DUCT (for 4WD)

(a) Remove the 4 clips and cool air intake duct.

5. REMOVE FRONT BUMPER LOWER COVER

(a) Remove the clip.

(b) Remove the 4 bolts and front lower bumper cover.

6. REMOVE AIR INTAKE DUCT LH

(a) Remove the clip and bolt.

(b) Remove the 2 screws and air intake duct LH.

7. REMOVE AIR INTAKE DUCT RH

HINT:

Use the same procedure as for the LH side.

8. REMOVE RADIATOR SIDE DEFLECTOR LH

9. REMOVE RADIATOR SIDE DEFLECTOR RH

10. REMOVE FRONT BUMPER ENERGY ABSORBER

11. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

(a) Remove the screw, 6 nuts and front bumper reinforcement sub-assembly.

12. REMOVE NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH

13. REMOVE NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

14. REMOVE FRONT BUMPER SIDE SUPPORT LH

15. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure as for the LH side.

16. REMOVE FRONT BUMPER BRACKET SUB-ASSEMBLY LH

17. REMOVE FRONT BUMPER BRACKET SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE RADIATOR GRILLE 2. REMOVE NO. 2 ENGINE ROOM WIRE (a) Disconnect each connector. (b) Detach the 9 clamps to remove the No. 2 engine room wire. 3. REMOVE NO. 1 ...

Other materials about Toyota 4Runner:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very usefu ...

Illumination Circuit
DESCRIPTION Power is supplied to the radio and display receiver assembly and steering pad switch illumination when the light control switch is in the tail or head position. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for c ...