Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL WIRELESS DOOR LOCK BUZZER
(a) Connect the connector.
(b) Attach the clamp to install the wireless door lock buzzer.
2. INSTALL FRONT FENDER LINER LH (w/ Intuitive Parking Assist System)
(a) Install the front fender liner LH with the 13 new grommets, clip and 7 screws.
3. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH (w/ Intuitive Parking Assist System)
.gif)
4. INSTALL ROCKER PANEL MOULDING LH (w/ Intuitive Parking Assist System)
5. INSTALL FRONT FENDER MUDGUARD LH (w/ Intuitive Parking Assist System)
6. INSTALL FRONT FENDER LINER LH (w/o Intuitive Parking Assist System)
(a) Install the front fender liner LH with the 13 new grommets and 5 screws.
7. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH (w/o Intuitive Parking Assist System)
8. INSTALL ROCKER PANEL MOULDING COVER LH (w/o Intuitive Parking Assist System)
9. INSTALL FRONT FENDER MUDGUARD LH (w/o Intuitive Parking Assist System)
10. INSTALL FRONT WHEEL
Torque:
for aluminum wheel :
103 N·m {1050 kgf·cm, 76 ft·lbf}
for steel wheel :
112 N·m {1142 kgf·cm, 83 ft·lbf}
Inspection
INSPECTION
PROCEDURE
1. INSPECT WIRELESS DOOR LOCK BUZZER
(a) Measure the resistance according to the value(s) in the table below.
HINT:
The buzzer activation circuit is built into ...
Other materials about Toyota 4Runner:
Inside rear view mirror
Glare from the headlights of vehicles behind can be reduced by using the
following functions:
Manual anti-glare inside rear view mirror
1. Normal position
2. Anti-glare position
Auto anti-glare inside rear view mirror
In automatic mode, sensors are u ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE TRANSMISSION CONTROL SHAFT LEVER LH
(a) Remove the nut, spring washer and control shaft lever LH.
2. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Using a screwdriver, bend the tabs of the lock washer.
(b) Remove th ...
0.015