Toyota 4Runner: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page
.gif)
).
(b) With the lower No. 1 instrument panel airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 1 instrument panel airbag with a new one:
Cuts, minute cracks or marked discoloration on the lower No. 1 instrument panel airbag.
2. CHECK LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check (See page
).
(b) With the lower No. 1 instrument panel airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 1 instrument panel airbag with a new one:
- Cuts, minute cracks or marked discoloration on the lower No. 1 instrument panel airbag.
- Cracks or other damage to the connector.
- Deformation or cracks in the instrument panel reinforcement.
CAUTION:
For removal and installation of the lower No. 1 instrument panel airbag, be sure to follow the correct procedure.
Components
COMPONENTS
ILLUSTRATION
...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS sys ...
Other materials about Toyota 4Runner:
Radio Receiver
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
3. REMOVE HEATER CONTROL ASSEMBLY
4. REMOVE RAD ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
0.027