Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL CENTER POWER OUTLET SOCKET COVER
(a) Attach the 2 claws to install the center power outlet socket cover.
HINT:
Use the same procedure as for the other sides.
2. INSTALL NO. 3 POWER OUTLET SOCKET ASSEMBLY
(a) Attach the claw to install the No. 3 power outlet socket assembly.
(b) Attach the connector clamp.
HINT:
Use the same procedure as for the other sides.
3. INSTALL REAR CONSOLE END PANEL
.gif)
4. INSTALL NO. 1 POWER OUTLET SOCKET COVER
(a) Attach the 2 claws to install the No. 1 power outlet socket cover.
5. INSTALL NO. 1 POWER OUTLET SOCKET ASSEMBLY
(a) Attach the claw to install the No. 1 power outlet socket assembly.
(b) Connect the No. 1 power outlet socket assembly connector.
6. INSTALL REAR CONSOLE BOX ASSEMBLY
7. INSTALL NO. 2 CONSOLE BOX RETAINER
8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A)
10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
11. INSTALL FRONT NO. 2 CONSOLE BOX INSERT
12. INSTALL FRONT NO. 1 CONSOLE BOX INSERT
13. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
14. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
...
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
3. REMOVE FRONT NO. 1 CONSOLE BOX INSERT
4. REMOVE FRONT ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
PROCEDURE
1. ADJUST COMPRESSOR OIL
(a) When replacing the compressor and magnetic clutch with a new one, gradually
discharge the refrigerant gas from the service valve and drain the following amount
of oil from the new compressor and magnet ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
0.0265