Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL REFRESHING SEAT SWITCH
(a) Attach the 4 claws to install the refreshing seat switch.
2. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
.gif)
3. INSTALL NO. 2 CONSOLE BOX RETAINER
4. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A)
7. INSTALL HEATER CONTROL ASSEMBLY
8. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
9. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
11. CHECK SRS WARNING LIGHT
(See page )
Inspection
INSPECTION
PROCEDURE
1. INSPECT REFRESHING SEAT SWITCH
Text in Illustration
*a
Component without harness connected
(Refreshing Seat Switch)
*b
Blowe ...
Other materials about Toyota 4Runner:
Rear Power Outlet Socket
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE POWER OUTLET SOCKET BEZEL (w/o Smart Key System)
(a) Put protective tape around the power outlet socket bezel.
Text in Illustration
*1
...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
0.0094