Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Interior / Seat / Power Seat Switch / Installation

INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FRONT POWER SEAT SWITCH LH

(a) Connect the power seat switch connector.

(b) Install the power seat switch with the 3 screws.

2. INSTALL FRONT SEAT CUSHION SHIELD LH

3. INSTALL RECLINING POWER SEAT SWITCH KNOB

4. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

5. INSTALL FRONT SEAT ASSEMBLY

(a) Install the front seat assembly (See page
).

Removal

REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the RH and LH sides. The procedure li ...

Rear No. 1 Seat Assembly(for 60/40 Split Double-folding Seat Type Lh Side)

...

Other materials about Toyota 4Runner:

LIN Communication Bus Malfunction (B2325)
DESCRIPTION The main body ECU (multiplex network body ECU) intermittently monitors the LIN communication bus between the components related to the doors and sliding roof ECU (sliding roof drive gear sub-assembly)*. DTC B2325 is stored when a malfunction ...

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. WIRING DIAGRAM HINT: When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspec ...