Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Drivetrain / Drive Shaft / Propeller Shaft / Propeller Shaft Assembly(for 2wd) / Installation

INSTALLATION

PROCEDURE

1. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Remove SST from the extension housing.

SST: 09325-40010

(b) Install the propeller shaft assembly to the extension housing.

(d) Install the propeller shaft assembly with the 4 washers, 4 bolts and 4 nuts.

Torque:

88 N·m {899 kgf·cm, 65 ft·lbf}

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same procedure for all rear propeller shaft universal joint spider bearing. (a) Apply ...

Propeller Shaft Assembly(for 4wd)

...

Other materials about Toyota 4Runner:

Voice is not Recognized
PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Proceed to System voice recognition level is low with an ...

Parking Brake Switch Circuit
DESCRIPTION This circuit is from the parking brake switch assembly to the radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK BRAKE WARNING LIGHT (a) Check that the brake warning light comes on when t ...