Toyota 4Runner: Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT
HINT:
- Perform this check with the portable player volume set at an appropriate level.
- Make sure that there are no obstructions between the portable player and navigation receiver assembly that may block signals, and that the portable player and navigation receiver assembly are not excessively far apart.
- Make sure that devices other than the navigation receiver assembly are not connected to the portable player.
- Make sure that there is no interference from a wireless LAN, etc.
PROCEDURE
|
1. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check that the same problem does not occur in the sound heard from the speakers on another "Bluetooth" audio compatible vehicle of the same model.
OK:
The same problem does not occur in the sound heard from the speakers.
| NG | .gif) |
MALFUNCTION IN PORTABLE PLAYER |
|
.gif)
|
2. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.
OK:
The same problem does not occur in the sound heard from the speakers.
| OK | |
END |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT
NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type
satellite radio broadcasts, registration of the XM radio ID is necessary.
HINT: ...
Portable Player cannot be Operated Using In-vehicle Device or Track Information
is not Displayed on In-vehicle Device
PROCEDURE
1.
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL
(a) Check if track information is displayed normally on another "Bl ...
Other materials about Toyota 4Runner:
Steering Knuckle(for 2wd)
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. DISCONNECT CABLE FROM ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Trouble Codes.
(e) Check for DTCs.
2. CLEAR DTC
(a) Connect the Tech ...
0.0129