Toyota 4Runner: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
|
(a) Check the fluid level and add fluid if necessary. Brake Fluid: SAE J1703 or FMVSS No. 116 DOT3 HINT: Add fluid to the reservoir MAX line. |
|
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
NOTICE:
As brake fluid may overflow, do not leave the brake fluid can in the
reservoir filler opening when adding brake fluid.
Do not allow brake ...
Other materials about Toyota 4Runner:
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE REAR PROPELLER SHAFT ASSEMBLY
(a) for 2WD:
Remove the rear propeller shaft assembly (See page
).
(b) for 4WD:
Remove the rear propeller shaft assembly (See page
).
2. REMOVE REAR DRIVE PINION NUT
(a) Using SST and ...
Vehicle Speed Signal Error (Test Mode DTC) (C2191/91)
DESCRIPTION
The tire pressure warning ECU receives a vehicle speed signal from the combination
meter. This DTC is stored upon entering test mode and cleared when a vehicle speed
signal of 20 km/h (12 mph) is detected for 3 seconds or more. This DTC is sto ...
0.0228