Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Back Door Outside Garnish / Installation

INSTALLATION

PROCEDURE

1. INSTALL BACK DOOR OUTSIDE GARNISH (w/o Smart Key System)

(a) Attach the 3 clips to install the back door outside garnish.

(b) Install the 4 nuts.

2. INSTALL BACK DOOR OUTSIDE GARNISH (w/ Smart Key System)

(a) Attach the 3 clips to install the back door outside garnish.

(b) Install the 4 nuts.

3. INSTALL BACK DOOR LOCK CYLINDER (w/o Smart Key System)

4. INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER

5. INSTALL MULTIPLEX NETWORK DOOR ECU

6. INSTALL BACK DOOR TRIM PANEL ASSEMBLY

7. INSTALL ASSIST STRAP ASSEMBLY

8. INSTALL ASSIST STRAP HOLE COVER

Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: When installing the back door outside garnish seal, heat the back door outside garnish surface using a heat light. Standard: Item ...

Black Out Tape(for Front Door)

...

Other materials about Toyota 4Runner:

Ignition Hold Monitor Malfunction (B2271)
DESCRIPTION This DTC is stored when a problem, such as an open in the AM2 fuse, an open or short in the wire harness between the fuse and power management control ECU, a short in the IG output circuit inside the power management control ECU, a short betwe ...

Front Axle Hub Bolt
Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE ...