Toyota 4Runner: Outside Vehicle

Toyota 4Runner Service Manual / General / Maintenance / Outside Vehicle

General Maintenance

GENERAL MAINTENANCE

CAUTION / NOTICE / HINT

Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tools are not required. It is recommended that the owner performs these checks. The procedures for general maintenance are as follows.

PROCEDURE

1. GENERAL NOTES

Maintenance requirements vary depending on the country.
Check the maintenance schedule in the owner's manual supplement.
Following the maintenance schedule is mandatory.
Determine the appropriate time to service the vehicle using either distance driven or time (months) elapsed, whichever reaches the specification first.
Maintain similar intervals between periodic maintenance, unless otherwise noted.
Failing to check each vehicle part could lead to poor engine performance and increased exhaust emissions.

2. TIRES

(a) Check the tire pressure with a gauge. Make adjustments if necessary.

(b) Check the surfaces of the tires for cuts, damage or excessive wear.

3. WHEEL NUTS

(a) Check for nuts that are loose or missing. Tighten the nuts if necessary.

4. TIRE ROTATION

(a) Check the maintenance schedule in the owner's manual supplement.

5. WINDSHIELD WIPER BLADES

(a) Check the blades for wear or cracks when they are unable to wipe the windshield clean. Replace them if necessary.

6. FUEL LEAKS

(a) Check under the vehicle for leaking fuel, oil, water or other fluids.

NOTICE:

If you smell gasoline fumes or notice any leaks, locate the cause and correct it.

7. DOORS AND ENGINE HOOD

(a) Check that all of the doors operate smoothly, and that all the latches lock securely.

(b) When the primary latch is released, check that the engine hood secondary latch prevents the hood from opening.

Inside Vehicle

General Maintenance GENERAL MAINTENANCE CAUTION / NOTICE / HINT Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenan ...

Under Hood

General Maintenance GENERAL MAINTENANCE PROCEDURE 1. GENERAL NOTES Maintenance requirements vary depending on the country. Check the maintenance schedule in the owner's manual sup ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL POWER MANAGEMENT CONTROL ECU (a) Attach the 2 claws to install the power management control ECU. 2. ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Main Body / Trouble Codes. (e) Check for DTCs. 2. CLEAR DTC (a) Conn ...