Toyota 4Runner: Portable Player cannot be Connected Manually/Automatically

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Audio / Video / Audio And Visual System / Portable Player cannot be Connected Manually/Automatically

CAUTION / NOTICE / HINT

HINT:

Some versions of "Bluetooth" compatible audio players may not function, or the function may be limited using the radio and display receiver assembly, even if the portable audio player itself can play files (See page ).

PROCEDURE

1.	CHECK CONNECTED DEVICE SETTINGS

(a) Check if the portable player is registered as a connected device.

NOTICE:

If a cellular phone is used as a portable player, it must be registered independently from the registration that is performed for the hands-free system.

HINT:

Only 5 portable players can be registered.

Result	Proceed to
The portable player is registered as a connected device.	A
The portable player is not registered as a connected device.	B

2.	CHECK SYMPTOMS

(a) Check the connection condition between the portable player and radio and display receiver assembly.

The portable player cannot be connected under any of the following conditions:

The portable player is connected to another device.
The portable player is connected to the radio and display receiver assembly using the hands-free function.
The radio and display receiver assembly has cleared the portable player registration.
The portable player is off.

Result	Proceed to
The portable player cannot be connected automatically.	A
The portable player cannot be connected manually.	B

GO TO STEP 4

3.	CHECK AUTOMATIC CONNECTION SETTINGS

(a) Check the automatic connection settings of the "Bluetooth" audio.

(1) Check that the "Bluetooth" connection is on.

OK:

"Bluetooth" connection is on.

TURN "Bluetooth" POWER TO "On"

4.	CHECK PORTABLE PLAYER STATUS

(a) Check the status of the portable player.

(1) Check that the portable player is not in standby mode.

(2) Check that the portable player is not connected to another device (headphones etc.).

OK:

The portable player is not in standby mode and not connected to another device (headphones etc.).

TAKE PORTABLE PLAYER OUT OF STANDBY MODE AND DISCONNECT OTHER DEVICES (HEADPHONES etc.)

5.	CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check if the portable player can be connected manually/automatically on another "Bluetooth" audio compatible vehicle of the same model.

OK:

The portable player can be connected manually/automatically.

PORTABLE PLAYER IS NOT COMPATIBLE

6.	REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES

(a) Remove additional devices which use radio waves.

(b) Check if the portable player can be connected manually/automatically.

OK:

The portable player can be connected manually/automatically.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure that there are no obstructions between the portable player ...

Registered Device cannot be Deleted

PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK ...

Other materials about Toyota 4Runner:

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Center airbag sensor assembly Main body ECU (multiplex network body ECU) Front seat inner belt LH buckle swit ...

Zero Point Calibration of Yaw Rate Sensor Undone (C1210,C1336)
DESCRIPTION The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system. The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2). If t ...