Toyota 4Runner: Diagnosis System

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Automatic Running Board System / Diagnosis System

DIAGNOSIS SYSTEM

1. FUNCTION OF AUTOMATIC RUNNING BOARD WARNING LIGHT

(a) When a malfunction is detected in the automatic running board system, the automatic running board warning light in the combination meter comes on to inform the driver of the malfunction.

(b) The operation and condition of this control are described below.

Operation	Condition
Comes on	When the jam protection function has operated.1 When the automatic running board is not fully stowed while the vehicle is moving (at a speed of 8 km/h [5 mph] or more).2
Blinks	When a DTC has been output.

HINT:

*1: The automatic running board warning light turns off when the automatic running board is deployed or stowed normally with the operation of the doors. Also, the warning light will turn off 20 minutes after it is lit.
*2: The automatic running board warning light turns off when the automatic running board is stowed normally. Also, the warning light will turn off 20 minutes after it is lit.
*3: The automatic running board warning light turns off when the abnormal state of the automatic running board system is resolved, and the system returns to a normal state. Also, the warning light will turn off 20 minutes after it is lit, even if the abnormal state is not resolved.

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Measure the voltage according to the value(s) in the table below. Ter ...

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota 4Runner:

Red Indicator Remains On
DESCRIPTION This means that the DCM (Telematics Transceiver) detects a malfunction in the Safety Connect and stores a DTC. PROCEDURE 1. CHECK FOR DTC (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR AXLE SHAFT LH (a) Remove the rear axle shaft LH (See page ). 2. REMOVE REAR AXLE SHAFT RH HINT: Use the same procedure described for the LH side. 3. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft asse ...