CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function, or the
function may be limited using the navigation receiver assembly, even if the portable
audio player itself can play files (See page
).
PROCEDURE
|
1. |
CHECK THAT PORTABLE PLAYER IS "Bluetooth" AUDIO COMPATIBLE |
(a) Check if the portable player is "Bluetooth" audio compatible.
|
Result |
Proceed to |
|---|---|
|
The portable player is "Bluetooth" audio compatible. |
A |
|
The portable player is not "Bluetooth" audio compatible. |
B |
| B | |
USE A "Bluetooth" AUDIO COMPATIBLE PORTABLE PLAYER |
|
|
2. |
CHECK CONNECTION PROCEDURE OF CONNECTED DEVICE |
(a) Referring to the owner's manual, correctly register the portable player.
(b) Check that the portable player has been registered as a connected device.
The portable player cannot be registered under any of the following conditions:
OK:
The portable player has been registered as a connected device.
| OK | |
END |
|
|
3. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check if the portable player can be registered normally on another "Bluetooth" audio compatible vehicle of the same model.
OK:
The portable player can be registered.
| NG | |
MALFUNCTION IN PORTABLE PLAYER |
|
|
4. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Place the portable player close to the navigation receiver assembly.
(c) Check that the portable player can be registered as a connected device.
OK:
The portable player can be registered.
| OK | |
END |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Registered Device cannot be Deleted
USB Audio System Recognition/Play ErrorMenu list of the Bluetooth® audio system
“BT Audio Setup” can be canceled by pressing the on-hook switch or saying the
voice command, “Cancel”.
When using a voice command
For numbers, say a combination of single digits from zero to nine.
Say the command correctly and clearly.
Situat ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT DRIVE SHAFT DUST COVER
(a) Using SST and a press, install a new dust cover.
SST: 09527-10011
2. INSTALL SHAFT SNAP RING
(a) Install a new snap ring.
3. INSTALL OUTBOARD JOINT BOOT
HINT:
Before installing the ...