Toyota 4Runner: Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (position) |
Engine Switch (condition) |
|---|---|---|
|
Ignition Switch off |
Off |
Off |
|
Ignition Switch ON |
ON |
On (IG) |
|
Ignition Switch ACC |
ACC |
On (ACC) |
|
Engine Start |
START |
Start |
2. AUTOMATIC RUNNING BOARD SYSTEM PRECAUTIONS
(a) When the side auto step controller ECU assembly is replaced, the side auto
step controller ECU assembly must be initialized (See page
.gif)
).
Parts Location
PARTS LOCATION
ILLUSTRATION
...
System Diagram
SYSTEM DIAGRAM
...
Other materials about Toyota 4Runner:
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE HOOD TO RADIATOR SUPPORT SEAL
(a) Using a clip remover, remove the 7 clips and hood to radiator support
seal.
NOTICE:
If the clips are damaged or fall off, replace them with new clips.
...
Four-wheel drive system (full-time 4WD models)
Use the four-wheel drive control switch to select the following transfer
modes:
1. H4F (high speed position)
Use this for normal driving on dry hard-surfaced roads. This position gives
greater economy, quietest ride and least wear.
2. H4L (high speed ...
0.1404