Toyota 4Runner: Automatic Running Board System
Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Automatic Running Board System
- Parts Location
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Data List / Active Test
- Dtc Check / Clear
- Diagnostic Trouble Code Chart
- Motor LH Over Temperature (64,65)
- Motor LH Current Senser (62,63)
- ECU Circuit (61)
- Hall Effect Sensor LH (43,44)
- Side Auto Step LH Stowing Timeout (51-56)
- Hall Effect Sensor LH Pulse (41,42)
- Short to Battery in Hall Effect Sensor Power Circuit (32)
- Short to Battery in Motor RH Circuit (25,26)
- Short to GND in Hall Effect Sensor Power Circuit (31)
- Open in Motor LH Circuit (22,24)
- Short in Motor LH (11,12)
- Short to GND in Motor LH Circuit (21,23)
- Side Auto Step ECU Power Source Circuit
- Side Auto Step Switch Circuit
- Door Courtesy Switch Circuit
- Speed Signal Circuit
Automatic Running Board Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH
2. REMOVE COWL SIDE TRIM BOARD LH
3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANE ...
Parts Location
PARTS LOCATION
ILLUSTRATION
...
Other materials about Toyota 4Runner:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH
3. REMOVE FRONT DISC
4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator, measure the looseness near the center of
the ...
Transmitter ID not Received in Main Mode (C2126/26)
DESCRIPTION
After all IDs are registered, DTC C2126/26 is stored in the tire pressure warning
ECU and the tire pressure warning light blinks for 1 minute and then comes on.
When the tire pressure warning ECU successfully receives information from all
the ...
© 2016-2026 | www.to4runner.net
0.0276
0.0276