Toyota 4Runner: Precaution

Toyota 4Runner Service Manual / Vehicle Exterior / Wiper / Washer / Wiper And Washer System / Precaution

PRECAUTION

1. IGNITION SWITCH EXPRESSION

HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression	Ignition Switch (position)	Engine Switch (condition)
Ignition Switch off	Off	Off
Ignition Switch ON	ON	On (IG)
Ignition Switch ACC	ACC	On (ACC)
Engine Start	START	Start

2. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with a safety pin, etc. for the following reasons:

(1) The washer nozzle tip is made of resin and could be for the following reasons.

(2) Adjustment is not necessary for this spray-type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.

Parts Location

PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: Be sure to read PRECAUTION before performing this procedure (See page ). PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE REAR WHEEL 3. REMOVE CENTER CONTROL ABSORBER ASSEMBLY LH (a) While using a wrench to ...

Back Door Garnish(for Side)
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL BACK DOOR OUTSIDE MOULDING LH (a) Attach the 5 clips to install the back door outside moulding. 2. INSTALL BACK DOOR OUTSIDE MOULDING RH HINT: Use the same proced ...